FAQs
More FAQs- Are there instructions to follow after my carpets are cleaned?
- How long will it take to have my floors coated with acrylic?
- Is urethane slippery when wet?
Immediately after cleaning, it’s best to allow carpets to dry for 6-8 hours before walking on them. Walking on them may flatten the fibers. Use air movers if needed to help air circulation as this will speed up the drying time. If a carpet protector such as ScotchgardTM was applied, foot traffic should be minimized for up to 24 hours to let the product cure. Don’t move any furniture back in place until carpet is completely dry or the Scotchgard carpet protector has cured.
Preparation will depend on the condition of the existing floor, current number of coats, repairs required, etc. When applying an acrylic finish, stripping of the old finish is usually necessary. When that’s the case, finish removal plus the application of 3 coats of finish requires 1 hour for every 150 square feet of flooring. Generally, 3 coats of finish are required to achieve the desired effect. If a floor does not require stripping, it can generally be shower scrubbed which is a procedure used for preparing a floor for receiving a new layer of finish. Once that has taken place, a floor can be recoated at anywhere from 4,000 to 6,000 square feet per hour.
Any coated surface can be slippery when wet. Our urethane product is considered to have acceptable slip resistance according to the American National Standards Institute (ANSI)/National Floor Safety Institute (NFSI) B101.3-2012 test method for measuring wet dynamic coefficient of friction (DCOF) of common hard-surface floor materials. We offer optional additives to create high slip resistance (lower probability of slipping) for wet environments or areas of concern.